Militec-1® is a clear golden synthetic liquid resembling an SAE 10-weight oil. When Militec-1® is added to the primary lubricant of any machine, it will increase operating efficiency, extend equipment life, reduce downtime, and cut unscheduled maintenance.
MILITEC-1® can be used with petroleum, mineral, parasynthetic and synthetic oils and greases in the following applications and ratios for heavy equipment:
Bulldozers • Backhoes • Road Graders • Buses • Track Vehicles • Forklifts • Cranes • Trucks • Vehicles • Railroad
All gasoline and propane-powered engines: Add 8 ounces for a 4 to 6 quart/liter engine oil crankcase capacity every 15,000 miles (24,000 KM). Always change oil at the manufacturer’s recommended oil change intervals.
CHARACTERISTICS: MILITEC-1® Synthetic Metal Conditioner has the unique ability to create a complex, molecular compound within the surface of heated gunmetal. This causes MILITEC-1® to become part of the metal, not merely a temporary coating or a boundary film.
Some lubes can leave a residue that may parally block MILITEC-1®’s effectiveness. If you’ve used older lubes extensively, or if your firearm is very dirty, it’s a good idea to clean it thoroughly with a good quality solvent before your first application of MILITEC-1®.
MILITEC-1® has been tested extensively in the sweltering jungles of Panama and Colombia, the frigid winters of Alaska and Minnesota, the dry blowing dust and sand of Desert Storm, and the soggy rain of Great Britain, Puget Sound and New England. In all these condions, MILITEC-1 ® weapons fired first time, every time.
It doesn’t! MILITEC-1® is extremely concentrated. A single 1 oz. bottle of MILITEC-1 ® usually lasts far longer than a 4 oz. bottle of other lubes.
MILITEC-1® is extremely concentrated. A single 1 oz. bottle of MILITEC-1 ® usually lasts far longer than a 4 oz. bottle of other lubes. Other lubricants form a temporary coating on the surface of the metal - a coating that can dry out or get rubbed off, leaving the weapon unprotected. In contrast, MILITEC-1 ® actually becomes part of the metal, not merely a film on the surface. MILITEC-1® has been tested extensively in the sweltering jungles of Panama and Colombia, the frigid winters of Alaska and Minnesota, the dry blowing dust and sand of Desert Storm, and the soggy rain of Great Britain, Puget Sound, and New England. In all these conditions, MILITEC-1 ® weapons fired the first time, every time. If you’ve used older lubes extensively, or if your firearm is very dirty, it’s a good idea to clean it thoroughly with a good quality solvent before your first application of MILITEC-1®. Some lubes can leave a residue that may partially block MILITEC-1®’s effectiveness.
Just fine. To get maximum benefit, fire at least one shot with a slightly wet coating of MILITEC-1® in the bore, then return to normal dry-bore conditions.
Great! MILITEC-1® has been used on stainless steel weapons for many years with complete success.
MILITEC-1® will not harm your ammo.
Absolutely not. MILITEC-1® has no effect on primers.
No! If anything, MILITEC-1® will add new luster and depth to the finish.
MILITEC-1® has been used on stainless steel weapons for many years with complete success and also works with black powder firearms. MILITEC-1® will not harm the bluing and will add new luster and depth to the finish. MILITEC-1® has
no effect on primers and will not harm ammo.